INTRATEC TEC-22

25 ROUND MAGAZINE WITH ALUMINUM BODIES

18 Week Back Order

MACHINED FROM SOLID ALUMINUM BARS. The TI25 Machined Aluminum Magazine is the toughest, most durable magazine on the market without exception. The 2 body halves are machined one at a time from T6 aircraft aluminum bar using the same precision and tolerances as space and defense and aircraft parts.

COMPLETELY DISASSEMBLE TO CLEAN OR SERVICE. Anyone that's shot 22 rimfire ammo knows how dirty it is and a lot of crud gets into the inside of the magazine which makes a magazine less reliable. That problem no longer exists with the TI25 magazine. Three stainless steel cap screws make it easy to disassemble the magazine for cleaning. Scrub the inside with hot soapy water, dry and reassemble and its as clean as it when it was new.

PRECISION ADJUSTABLE TO EXACTLY FIT YOUR GUN. Have you ever wondered about the amount of wiggle in all other high capacity 22 magazines? A magazine should not when its in the gun.  What separates this magazine from the others is the ability to adjust (1)FEED ANGLE, (2) FEED HEIGHT and (3) EJECTOR TO BOLT DISTANCE. Four cap screws on the top of the magazine mate with your receiver allowing the magazine to quickly be precision adjusted for an exact fit in your gun by minimally increasing or decreasing the individual heights of each of the cap screws (like leveling an appliance), resulting in a magazine that has minimal to no wiggle in your gun and that works!. The ability to quickly one time precision adjust it to your gun means that you can count on reliable feeding every time.

HARDENED STAINLESS STEEL REPLACEABLE FEEDLIPS. The most critical part of the magazine other than its precise adjustment in the gun, is the feedlips. The TI25 Magazine uses replaceable hardened stainless steel feedlips to ensure that the feed angle remains consistent. The hardened stainless steel feedlips also incorporate an ejector that can take a pounding from thousands of rounds of brass and still keep kicking them out hard. Magazines with plastic feedlips and plastic ejectors cannot keep up with the strength and durability of stainless steel.

$94.95 each

email questions to:lostfan2@comcast.net